This is documentation of a bèta release.
For documentation on the current version, please check Knowledge Base.

Measurements using Point Cloud

This page documents the Point Cloud Measure Technique for Basic Measurements.
For more information on 3D Measurements, see Measure.

Point Cloud Measure Technique

3 techniques 3 different results.

In Desktop one can set via the 3D Hover, see Preferences of 3D Hover and Measurements.
In the WebClient the 3D Hober get be set using the Viewer and View Settings

Closest Point

The measurement technique Closest Point selects automatically the nearest point available of the point cloud, considering the XYZ of the startup measured point. Closest Point technique is advised for high density point clouds.

Flat Surface Intersection

In the flat surface intersection, a point is created using interpolation method within the range of a set of pre-defined point cloud points. It is possible to configure settings such as search radius and minimum number of use points in the Preferences of the 3D Hover. The flat surface Intersection technique is advised for less dense point clouds.

Ridge and Corners Intersection

Ridges and corners Intersection technique follows the same principles of flat surface intersection interpolation method and identifies where edges, ridges and corners are existent, for example, in the side of roads and corners of buildings.

Restrictions by Legend

Only rendered points will be used.

If the Orbit Desktop has direct file access to the Orbit Run containing the Orbit Point Cloud files coordinate measurements using point cloud are calculated client side according the principle of “what you see is what you get”1) and Orbit Desktop's 3D Hover setting :

Point Cloud measurement on Images

Point Cloud doesn't need to be visible to be rendered.

The Orbit Mapping Desktop Clients are using Orbit's generic 3D Hover concept, see above “Preference of 3D Hover”.

One extra functionality is added. On using the Mobile Mapping Image View the point cloud doesn't need to be set visible on the image to be used by the 3D Hover. The Point Cloud Legend & Viewing Restrictions are taken into account at all time, even if the point cloud is set to be invisible.

1)
The point cloud overlay on image doesn't need to be visible to be used. But point cloud legend restrictions are still applied.
 
Last modified:: 2023/10/24 09:37