Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
dev:viewer:viewmodes:reference [2019/02/11 15:10] nathalie.moerman@orbitgt.com |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Reference View ===== | ||
- | |||
- | This page explains how to use the Reference View of the [[dev: | ||
- | |||
- | {{: | ||
- | |||
- | ==== The reference basemap ==== | ||
- | |||
- | **Change basemap in viewer** \\ Using the drop-down list from the right upper corner of the 2D Map component it is possible to switch between available basemaps. | ||
- | |||
- | **Change available basemaps** \\ Available basemaps and vector overlays are managed by the Orbit administrator and can not be changed in the Web Viewer. Any combination of [[dev: | ||
- | |||
- | <note tip> | ||
- | |||
- | ==== Display of data coverage ==== | ||
- | |||
- | How the data coverage is displayed on the Reference View depends on the data type of the available resources. | ||
- | |||
- | ** Mobile Mapping and Planar Photo Positions ** | ||
- | |||
- | * Blue dots: Represent the photo positions or recording locations. These are visible up to a map scale of 1/1500. \\ | ||
- | * Blue pie-slices: Heading and field of view of a Mobile Mapping View. The number on the pie-slice corresponds to the number of the view. | ||
- | |||
- | Photo positions can be turned on/off from the [[dev: | ||
- | Check the page " | ||
- | |||
- | ** Oblique Footprints ** | ||
- | |||
- | * Blue quadrangle: the border of the footprint of the active photo. | ||
- | * Green cross: Center of Oblique View. | ||
- | * Red cross: Location of the cursor on Oblique View. | ||
- | |||
- | Footprints can be turned on/off from the Resources sidebar. \\ | ||
- | |||
- | ==== Vector overlays ==== | ||
- | |||
- | Vector layers are by default not displayed in the Reference View. This can be changed in the Settings menu. | ||
- | |||
- | How vector overlays are displayed is dependent of the legend of the vector layer. This can be set in the Resources sidebar. | ||
- | Note, a vector dataset may not be visible due to scale limit limitations. | ||
- | |||
- | ==== Search on Map ==== | ||
- | |||
- | The Search Box on top of the Reference View gives access to all available search engines as configured by the administrator. | ||
- | |||
- | Using this entry field it is possible to search for a location and open the closest image. A successful search request will center and zoom the map to the returned bounding box and update the left most image view focusing to the requested location. If no bounding box is returned by the search engine the map will only be centered around the location that was searched for. | ||
- | |||
- | ** Geocode ** | ||
- | |||
- | Enter address or location specifications according the capabilities of the used geocode plugin. \\ | ||
- | Geocoding services are varied, and implementation cannot be standardized. Therefore Orbit delegates the implementation of a geocoding service to the administrator. Contact your administrator for more information. | ||
- | |||
Last modified:: 2019/02/11 15:10