This page describes the Orbit desktop extension “Automated Feature Extraction”.
Feature Extraction Pro
Main Toolbar > Extensions > Automated Feature Extraction
Automated Feature Extraction Extension is an extension devoted to finding features of certain type fully automatically based on a point cloud and set of user-defined parameters.
Independently of the type of the features we are looking for the same workflow is used:
Select one of the available detectors.
Pole detection is based on the geometry of the point cloud: poles are expected to be round and standing straight. Based on this assumption the process of detecting poles can be split in 3 main steps:
Traffic signs detection is based on point cloud reflective as well as shape recognition. Traffic signs are expected to have high percentage of highly reflective points and shape should be: triangle, round or square.
Select point cloud dataset drop-down menu
Choose one of the available in the Dataset List *.opc point cloud files to use in slope calculations.
Project
Choose where you want to store the Automated Feature Extraction results. A project represents an automatically created destination in the same folder where the source point cloud is stored.
For each run of Automated Feature Extraction extension a new project will be created. Writing new data in an existing project will overwrite existing data in that folder.
Options to create a new project, open a recent project, close or delete a project are available.
The Area of Interest (AOI) can be defined by
If AOI has not been defined the whole point cloud will be processed.
When creating a new project the parameters are read from Preferences of Detectors and basic set of the parameters is displayed on the sidebar; advanced parameters can be accessed by small grey circle above basic parameters.
Changing parameters in the sidebar influence the currently opened project immediately, while Parameters in the Preferences are only taken into account at the moment of Project creation.
'Test' allows to check if certain object will be detected by the extension as the feature of interest.
Measure
'Measure' allows you to measure the object you would like to test for conformity with the entered parameters.
Start
'Start' runs the above mentioned test. If object conforms with the parameters then the message “Feature is detected” will be shown, otherwise Orbit will provide a tip on the calculated statistics and recommendation on which parameters need to be changed for this feature to be detected as feature of interest.
Clear
Clears the measurement if present.
Get point cloud selection
If this check box is on the points from the point cloud belonging to the extracted features will be selected (*.ops file created)
Delegate to Task Manager
Allows to schedule job to be run later by delegating it to the Task Manager.
Start Now
Start calculating of the slopes immediately.
Shows amount of detected and candidate objects.
Results are saved in temporary files in the corresponding folder (see above) and also added to the dataset list as detected_features and candidate features.
Create theme
Creates Asset Inventory Theme which can be used for result's verification for example.
Start
Opens Asset Inventory Verify procedure.