Preferences of 3D Hover and Measure Techniques

This page describes Measure Technique and 3D Hover behavior and appearance preferences.

Main Toolbar > Preferences > 3D Hover

The 3D Hover (“yellow puck”) represents the on the fly detected 3D surface around the position of the mouse pointer. The hover is based on screen pixels within the given query “Search Radius” for which a coordinate is known. A pixel coordinate can be derived from any visible dataset object from point cloud, vector or image resources. Overlays are not taken into account.

If, given the 3D Hover Query settings, no 3D surface can be detected around the mouse pointer position as seen from the current 3D view point, no hover will be displayed no 3d coordinate measurement will possible.

There are 3 measure techniques available in Orbit which can be used depending on accuracy requirements and the data availability and quality, for more information see 3D Measurements.

Choose the measure technique to be used for measurements based on Point Cloud.

• Closest Point
• Flat Surface Intersection
• Ridges and Corners Intersection
  • Snap to ridge or corner

For more information about point cloud measurements, see Measurements using Point Cloud.

The use of a DEM simplifies a measurement. A coordinate measurement can be done with a single click in a single view, much faster compared to measurements by triangulation, but some experience and basic knowledge about elevation models is advised.

For more information about DEM based measurements, see Measurements using DEM.

• Forward intersection : measurement is based on triangulation.
• Reference planes intersection : coordinate measurement by intersecting the horizontal or vertical reference planes.

For more information about Image only measurements, see Measurements using Images Only

• Extend line measurement - Option to add an additional part to an ongoing object measurement. All parts will be saved as a single object.
• Enable linear referencing. For more information please check Linear Referencing page.
• Calculate center Z-range: enables extra measure attribute to calculate the point cloud z range (max z - min z) at the center of the measurement.

Define 3D Hover radius around the current mouse pointer position to select all pixels for which a 3D coordinate is known.

• Search Radius: minimum and maximum search radius in pixels.
• Min # points: minimum amount of detected points to form the hover.
• Min distance: minimum distance between the hover and the viewer focus position. In the image viewer this is equal to the photo position. In the 3D view this is equal to the position of the viewer focus.
• Cluster gap size: minimum distance between two points in order not to be consider part of the same cluster

If there aren't enough Pixel Coordinates (Min # points) within the defined Search Radius due to the above set conditions, no 3D Hover can be calculated, so no point cloud measurements will be possible.

Set the appearance of the 3D Hover

• Show hover
• Show used points
• Show search radius
• Show plane inclination as outline color
• Show point deviation as fill color
• Transparency